On the righthand side of the trailer there is on top a 230V CEE input for power from a landline or generator. No switches need to be switched. When connected the battery will automaticly charge at a rate of max 6 AH
Below there is the 12V solarpanel connector for 120W the flexible solarpanel. To use and charge the Battery the Solarpanel switch on the controlboard needs to be switched on.
On the bottom there is the water inlet, a key is with the trailer and it can hold approximately 90 Litres of fresh water
In the front of the trailer there is a 13Pole Trailerlight connector.
Furthermore, there is a Andersonplug to charge the battery directly from the car while driving. No switches need to be switched on the controlboard. A counterplug is provided and can be connected directly or over a switch to the onboard car battery. Please use a 16mm2 wires.
A optional gasoutput socket on the lefthand side of the trailer. Gashose needs to be connected before it is possible to open tap.
All doors lock and unlock with the same keys. 4 Keys are supplied with a trailer
All drawers have locking slides and some have security locks. Please note that all drawers are locked (clicking sound) before closing doors and before travel.
The kitchen is connected when in or out. To use water please switch on pump switch on controlboard. Pump is pressure activated and will turn on when tap is used. Please depressurise system when not in use.
Please put out support legs under kitchen drawer when drawer is used or slides out.
A gasbottle can be put in the rear righthandside compartment (optional 2 can be put in) please close gasbottles and depressurise gassytem when traveling or storing.
There is a jerrycan holder in the front righthandside compartment. It can be taken out by two bolts or a optional Jerrycan can be put in.
Under the drawers in the middle compartment on the lefthandside is the battery. This is standard a 100AH deepcyle. When the trailer is stored disconnect the +side and or charge the battery on a regular basis. This can either be done when disconnected with a suitable battery charger or when connected over the CEE power connection
Front compartment on the lefthandside is for the fridge. Please make sure that the fridge is fixed to the drawer while traveling. The fridge can be run over 12V during travel. Please switch on front fan on controlboard to circulate fresh air for cooling the fridge.
The solar panel can be connected to the trailer when there is no 230V connection. Switch it on on the controlboard and it will charge and supply the trailer with up to 120Watts off power.
Power switch - Shuts off 12V from battery
230V Sockets - Provide 230V while CEE is connected or inverter is on
12V and USB - Provide 12V and 5V USB charging when powerswitch is turned on
Round water meter - Shows approx. level of freshwater
12V Auto Fuses and overload protection
Switches and Fuses - Switch as indicated
DC and AC meters - Provide information on power and consumption
230V Fuse between CEE and trailer
Solarpower charger with overload fuse.
Maintenance free Knott Axle, after offroad (mud) spray down brakes.
Watertank, empty in winter and clean with watertankcleaner before use in new season
Nosewheel please turn up completely then fold down when traveling. Optional Fixed Lock SCM against theft when parked and during travel.
Support leg to stabilise trailer when putting tent up. Remove rear support legs and store before traveling. Front support legs can be put to top position.
In case off a optional sparewheel on the rear this should be locked while traveling and turned outside when putting the tent up
Tentpoles are being fixed after tensioning the canvas by the plastic poleclamps on the tentpoles.
The tent is covered on the trailer by a foilcover that is secured with velcro and a hd zipper which closses and opens on the rear off the trailer.
Fold the tent backwards and put support poles on rear in tent. Put tent pegs on the 4 corners first at trailer side and then at rear. pull tentfloor straith. then extend all framepoles in tent to max.
Please note tentpole layout.
For easy connection off the front tent attach this when main tent is still low, not put up in totall.
Put up main tent and roof off front tent then zip sidewalls to fronttent and after that the floor can be put in
Windows have either mes and cover or mesh, plastic and cover. Both cover and clear plastic can be opened, put up or rolled up, at your choice.
The ladder is used to get access to the main bed.